Heel Joint Resolution

I gave the styrene bits a good try, but in the end, there wasn’t enough material to hold onto with adhesive, and it didn’t work. Fortunately, disassembling the switch was straightforward, and I was able to adopt the better alternative with .01″x.025″x7mm “joint bars” soldered to the either side of the point, and slipped over […]

Point Hinge Ideas

If I’m honest with myself, I shouldn’t be surprised by a derailment at the heal of a switch. The hinge, based on the clever but fine rail joiner from proto87.com, was the most expedient solution to an age-old model railroad problem that I could think of when I was laying track. Considering this problem of […]

One small step…

I’ve spent a couple of days now puzzling over a derailment at the south end of the siding. The gauge is fine, almost too wide, and there is only the tiniest unevenness to the track. Then I got the phone out and shot a video on the far side, and the problem was immediately apparent. […]

1120 Gets a new Decoder

Open house mania is not finished as I’m expecting another visitor in just over a week. So, I’m wasting as little time as possible in getting 1120 running again. The new connectors arrived from Mouser almost overnight, and I drove out to the Far East to pick up a LokSound 5 decoder from Intercity Trains […]