Levelling the Turntable

My friend Scott Calvert invited me to an operating session on Thursday (check out his new website!).  Everyone (everyone!?) asked me how the turntable was coming along, and so, I guess it has been a while since the last update. The true story is that I have had a couple of killer weeks at work, […]

Read More Levelling the Turntable

Turntable girders

I started on the cosmetic girders for the turntable a few weeks ago when I was away on business and couldn’t make progress on the main body anyway. I confess I didn’t make all that much progress in the hotel as there was too much to do during the day, and I spent most of […]

Read More Turntable girders

Two Down, Two to Go

[Note, I mis-published this to the wrong blog last weekend. I’ve since finished the remaining two wheels] Today I managed to assemble two of the four wheels for the turntable. I would have had all four, but two of the trucks broke before I could finish them. I considered throwing in the towel, but decided […]

Read More Two Down, Two to Go

Turntable Wheel Plan

It was a bit of a late start this evening, and all I had time for was some thinking about the turntable wheels. These are N-scale freight wheels with the flanges turned off. I had been thinking of using the needle bearings for one side, but couldn’t think how I would get the axles in […]

Read More Turntable Wheel Plan

Ring Rail Do-Over

I finally pulled the trigger. The first attempt at laying the ring rail wandered too far from the middle of the ties, and so, this evening I pulled it all off for a redo. Despite several encouraging comments that the prototype probably wasn’t perfect either, and it would probably look fine once the ballast was […]

Read More Ring Rail Do-Over

Ring Rail Installed

I’m reading a wonderful book, Pirate’s Passage by William Gilkerson to the kids right now. One of the characters obviously has a taste for rum.  So inspired, I poured myself a glass and tackled the ring rail this evening. The gauge on the turntable worked perfectly. It took hardly any time to chase it around […]

Read More Ring Rail Installed

Getting Started on the Ring Rail

Well, despite the funk, I’m pressing on. A handful of supportive words from Mike Chandler at Scott Calvert’s operating session last night encouraged me. When I told him of my concern that the pit is not round enough, he opined, “a lot of them weren’t very round.” Well, okay, let’s go for it then. The […]

Read More Getting Started on the Ring Rail

Pit Progress

I seem to be in a bit of a funk over the turntable pit.  At the core, this probably means that I don’t like how it’s shaping up.  There are just too many inaccuracies, and they’re probably going to come back to bite me. Even so, I’ve managed to push ahead all the same.  The […]

Read More Pit Progress

Turntable Pit Curb

I’m finally back from my course, and sufficiently recovered from jet lag that I have some energy left over at the end of the day to do a little bit of modelling. So, I tackled the curb around the top of the turntable pit. I think most turntables must have these, otherwise ballast and stuff […]

Read More Turntable Pit Curb