1120 Gets a new Decoder

Open house mania is not finished as I’m expecting another visitor in just over a week. So, I’m wasting as little time as possible in getting 1120 running again. The new connectors arrived from Mouser almost overnight, and I drove out to the Far East to pick up a LokSound 5 decoder from Intercity Trains […]

Bachmann Connectors

If there is one good thing about the decoder in 1120’s tender blowing up right in front of Steve Stark’s eyes, which he brought all the way from Victoria so he could point them at Pembroke, it is that I get to replace the six wires between tender and engine. They may be 28- or […]

Engine sand

Even today, locomotives want a small amount of dry sand for traction. All my resources are tacit about where they kept engine sand in Pembroke in 1905. There is also zero information about the purpose of the third stall in the roundhouse. For years, I’ve thought there was probably a pile of sand somewhere and […]

Roundhouse Gets a New Floor

I’ve never been happy with the roundhouse floor. Being made from a thick layer of ballast, it was not flat, and some of the rocks were real ankle-turners. As a result, details like work benches and water barrels were crooked. As I had the roundhouse module off the layout to protect it while working on […]

Modelling on the Road

Years ago, I worked as a consultant for a database company. A road warrior, often away early Monday morning, returning home Friday evening. It seems like other modellers are able to get some modelling done while travelling; I’ve even heard of a pilot who would build models in the cockpit during long flights. However, the […]

Water Tower Complete

I think we’ll call the water tower complete for now. I wound up printing the ladder so I could get round rungs without losing my mind drilling holes. The wooden supports for the ladder are quite delicate, and the ladder just lies in there loose so I can remove the roof and mess with the […]

Water Tower Tank

Now we get to the meat of the matter: the tank is usually considered the hardest part about building a water tower. In my case, the hard work was mostly done in OnShape. The prototype tank in Wakefield has two different types of band connectors, and they are in different orientations. I copied these differences […]

Spout Installation

It took two attempts – the first with epoxy, and the second with CA – to get the spout and frame mounted on the base. The epoxy didn’t work out because even with help from my darling wife, I wasn’t able to clamp it where I wanted it. With CA, I could hold it by […]

Ball Float

The water tower received a brass ball float and mast. The ball will indicate the water level in the tank, and I will animate it to lower when the valve is open and slowly return to the top of the mast when the valve is closed.

Water tower Spout frame v2

After the experiments a few weeks ago, I thought it was just a matter of attaching the water tower spout and its frame to the base and hooking it all up to the final model. Unfortunately, there is a surprising amount of complexity in the “attach the spout frame to the base” part of the […]